Frequently asked questions about the DEXP M-1000V vacuum cleaner
What is the DEXP M-1000V, and what is it intended for?
The DEXP M-1000V is a stick/handheld vacuum cleaner for dry indoor cleaning. It operates upright or as a handheld cleaner after removing the extension shaft.
What are the power consumption and suction power?
Power consumption: 1000 W. Stated suction power: approximately 200 W (around 23 000 Pa).
What is the vacuum cleaner noise level?
Stated noise level: up to 78 dB. Household smartphone measurements sometimes give lower values (around 60–65 dB), but the documented figure should be used because measurement methods and conditions differ.
What cleaning type is supported, and what dust collector is used?
Dry cleaning is supported. The dust collector is a 0,8 L plastic cyclonic container with a fine filter (HEPA). The cyclonic system helps maintain consistent suction as the container fills under normal conditions.
Can this cleaner collect liquids?
No. The model is intended exclusively for dry cleaning; liquid collection is not provided.
How is the cleaner powered, and what voltage is required?
From 100–240 V AC mains, 50–60 Hz. Connection to a power bank or through USB is not supported.
What mains plug type does the DEXP M-1000V have?
The documentation does not specify plug type. European shipments generally use a two-pin Euro-style plug; the actual type may differ in some regions.
What are the cable length and operating radius?
Mains cord length: approximately 5 m. Operating radius: approximately 5,5 m.
What are the device dimensions and weight?
Approximate dimensions: 1100 x 254 x 136 mm. Weight: approximately 1,75 kg (without accessories).
Where are the motor and debris container located?
The motor assembly and container are at the bottom of the design, near the main brush.
What materials are used for the main components?
The housing is plastic and the extension shaft is metal. Large wheels on the main brush provide smooth movement.
.Which surfaces best suit the DEXP M-1000V?
Hard floors and low-pile carpets are optimal. High-pile carpet and deep-cleaning effectiveness is lower than with full-size models.
Is the cleaner suitable for pet fur?
Yes, it collects fur and hair well. Strong side exhaust may blow light fur around; keep the brush level and repeat passes if necessary.
Can the cleaner be used for vehicle cleaning?
Yes. Handheld mode (without the shaft) conveniently cleans seats, mats, and hard-to-reach areas with crevice and upholstery tools.
Can it clean beneath low furniture?
To a limited extent. The low-mounted housing and container restrict access beneath very low furniture.
Where is exhaust air directed, and does it affect cleaning?
Exhaust openings are at the rear/sides. With the housing steeply tilted, airflow may scatter uncollected dust; plan the cleaning route and move from clean areas toward dirtier areas.
Is power adjustment or indication provided?
No power adjustment or indication is provided. A handle-mounted switch turns the device on/off.
Is cleaning area illumination provided?
No. Working area illumination is not stated.
Is a turbo brush included?
No. The manufacturer does not specify a turbo brush for the DEXP M-1000V.
Is overheating protection provided?
Yes. Motor overheating protection is incorporated.
Is automatic cable rewind provided?
No. The cable is wound manually onto the provided hooks.
.Is app and smart home integration supported?
No. App control and smart home protocols are not supported.
Are attachments from other models compatible?
Compatibility is not guaranteed and depends on inlet shape and adapters. Use accessories providing unrestricted airflow and secure fit.
How does the DEXP M-1000V differ from the DEXP M-800V?
User reviews indicate that the M-1000V has greater suction, quieter operation, and a pivoting attachment; the M-800V is simpler and sometimes behaves more predictably on certain surfaces. Both are mains-powered stick vacuums with low exhaust outlets; selection depends on floor type and preferences.
Can the cleaner be used handheld?
Yes. Its stick/handheld design uses a removable metal shaft, allowing upright operation or holding the housing by its built-in handle.
Does the main brush have a pivot joint?
Yes. The main brush connects through a pivot for improved maneuverability.
How are the cleaner, cable, and attachments stored?
Cord hooks are provided on the housing/shaft, and the device can be stored upright. There is no dedicated attachment storage on the housing.
Which attachments are included, and what are they intended for?
The set usually includes a main floor/carpet attachment, a crevice tool for hard-to-reach areas, and an upholstery attachment. The upholstery tool may connect through an adapter with a round inlet.
How is the DEXP M-1000V switched on and controlled?
A power button on the handle controls operation. There is no power adjustment; only one mode is provided.
How can dust scattering by exhaust air be reduced?
Move the attachment without excessive tilting and plan the cleaning route. Unofficial shields to redirect exhaust (homemade deflectors) are possible, but such modifications are at the owner's risk and are not recommended by the manufacturer.
.How can consistent suction be maintained during cleaning?
Regularly empty the container and clean the fine filter, prevent overfilling, and check the air path and attachments for blockages. These measures help maintain manufacturer-stated suction.
Can fine construction debris be vacuumed?
This is not recommended. The model is for household use; abrasive dust and coarse particles accelerate filter blockage and component wear.
What limitations and characteristic features does the model have?
Power adjustment is absent; the main attachment may stick to lightweight coverings (thin linoleum, rugs). The low-mounted unit limits access beneath low furniture, and side exhaust can scatter light debris. Container capacity is small and requires frequent emptying.
Why might the attachment stick to lightweight linoleum?
High suction without power adjustment creates low pressure between the nozzle and surface. Use a shallower angle and short passes; lift the attachment if necessary.
What should be done if debris falls from the inlet when an attachment is removed?
Check for the rubber nonreturn valve in the inlet and inspect its condition. Without it, debris may fall back out.
Are noise and housing heating normal?
Moderate noise within the documented level and noticeable housing heating during prolonged use are acceptable. Keep filters clean and exhaust openings unobstructed for correct cooling.
.How should the container and filters be maintained?
The container is removed and cleaned manually. The fine filter (HEPA) is removable and replaced as it wears. An additional filter element protects the motor inside the housing.
Can the HEPA filter be washed?
Whether rinsing is permitted depends on the particular filter's markings and material. Without explicit permission, use dry cleaning (shaking/tapping). If rinsing is allowed, reinstall only when completely dry.
How often should the container and filter be cleaned?
Empty the container after each cleaning session and clean the filter as it becomes dirty. With intensive use, users often clean the filter every 1–2 sessions.
Where can filters and spare parts for the DEXP M-1000V be purchased?
Look for filters and components through authorized sellers and service departments. Availability may vary; temporary household solutions (such as a protective nylon filter cover) do not replace the original element and are used at the owner's risk.
Related articles:
DEXP M-800V Vacuum Cleaner FAQ
Deerma DX700S Vacuum Cleaner FAQ
Polaris PVCS 0725 Vacuum Cleaner FAQ
Polaris PVCS 6000 Energy Way Pro FAQ
Polaris PVCS 1146 Master Clean AQUA FAQ
Deerma DX118C FAQ
Polaris PVCS 1102 HandStickPRO+ FAQ
Xiaomi Vacuum Cleaner G20 Lite FAQ
Инструкции пользователя пылесосов |