Ultrasonic Humidifier RGB Lamp Anti-Gravity Humidifier Instruction Manual
Specifications
• Type: Humidifier
• Humidifier type: Steam
• Anti-allergenic filter: Yes
• Air aromatization: Yes
• Top-fill water tank: Yes
• Performance: 0.1 L/h
• Tank capacity: 350 ml
• Maximum noise level: 36 dB
• Power: 5 W
• Housing material: ABS plastic
• Dimensions: 235 x 238 x 80 mm
• Weight: 640 g
• Package dimensions: ~240 x 250 x 90 mm
• Package weight: ~700 g
• Primary housing material: Plastic
• Country of origin: China
Package contents
• Lamp
• Power cable
• Documentation
Operating instructions
1. Fill the tank with 350 ml (no more) of warm water. Exceeding this capacity may cause leakage.
The liquid consumption rate is 100 ml/hour. Recommended operation of the "humidifier" mode is no more than 8 hours.
2. To turn on the device, use the supplied power cable. Insert one end into the connector on the side of the lamp next to the buttons, and the other end into a USB adapter with a power rating of at least 15 W, then plug the adapter into the power supply. Once connected, the RGB Anti-Gravity Lamp will switch on automatically.
3. To change the lamp color, press the upper button with the light bulb icon. Use this button to select lighting mode and backlight color. To switch off the light, press the button several times until the lamp turns off.
4. The lower button controls the humidifier and “anti-gravity” fountain, as well as the power on/off function. If the fountain or humidifier does not start after connection, press the lower button.
Using the lower power button, operate the modes:
• one short press – activates lamp, humidifier, and anti-gravity mode;
• two short presses – activates anti-gravity mode;
• three short presses – activates humidifier mode.
Filling the "Anti-Gravity" water tank
To operate the “anti-gravity” fountain and humidifier, carefully remove the top cover and pour water into the tank. To remove the cover, gently pull on the wide opening so that the latches on both sides come free gradually. Avoid excessive force to prevent damage.
Once the cover is removed, fill the tank with water. After filling, wait 10–15 minutes before first use to allow the humidifier filter to absorb water. The device will not start until this process is complete.
(!) Warning! Do not overfill the tank. Water must not overflow beyond the container to prevent damage. To check the correct level, use the drop-shaped window on the housing. Fill until the matte section of the drop is covered, but not the transparent section.
Replace the cover and turn on the device using the button.
Moving the device
If transporting the lamp, dry it thoroughly beforehand. Leave the device in a dry, shaded area. Do not place it on heaters or use a hairdryer for drying.
.Safety precautions
• Do not attempt to disassemble or modify the device.
• Do not allow water to enter the lamp housing.
• If malfunction occurs, immediately disconnect from power supply.
• Wipe the housing thoroughly with a dry cloth if water splashes onto it.
• Do not use damaged cables or faulty power adapters.
User manuals for climate control equipment |