Steam Cleaner DF A001 Operating Instructions
Thank you for purchasing this product. Please read this user manual carefully before using the appliance, even if you are already familiar with the device. This manual contains important safety instructions and guidelines for proper technical maintenance of the appliance.
Technical Specifications
Type: Steam Cleaner
Model: DF A001
Rated voltage: 220–240 V AC
Power, W: 1000
Operating temperature: from -20°C to 50°C
Steam pressure, bar: 3.3
Steam output, g/min: 28
Water tank capacity, ml: 450
Heating time, minutes: 2
Cord length, m: 3
Dimensions: 28 x 13 x 22 cm
Weight: 1.23 kg without accessories
Country of manufacture: China
Warranty period: 1 year
Important Safety Instructions
(!) Warning! Ensure that the nozzle does not overheat during operation.
(!) Risk of burns! Avoid contact with emitted steam. Always store this appliance in a place inaccessible to children!
When using electrical appliances, basic safety precautions must be observed, and the following instructions should be followed:
1. Do not leave the appliance switched on without supervision. Before each cleaning or maintenance operation, disconnect the appliance from the mains and before filling or emptying the water tank.
(!) Caution! The safety cap (water filling cap) must NOT be opened while the appliance is in use.
2. The appliance must be stored in a place inaccessible to children and must not be used by children.
3. For safety reasons, the appliance should be assembled only in accordance with the operating instructions, connected, and operated in compliance with all safety guidelines provided in this manual. Use only accessories recommended by the manufacturer or supplied with the appliance.
4. Before use, inspect the appliance for any signs of damage. Do not operate the appliance if it or its power cord or plug are damaged. To ensure safety and prevent hazardous situations, repair of electrical appliances must be carried out only by a qualified electrician.
5. Do not operate the appliance if the power cord or plug is damaged. Do not use the power cord to carry the appliance. Ensure that the power cord does not come into contact with hot surfaces.
6. Before use, check the appliance and power cord for any damage.
7. After use, disconnect the appliance from the power outlet.
8. Ensure that the appliance is not tilted more than 45° during operation.
(!) Do NOT direct steam towards people, animals, plants, or other electrical appliances. Never immerse the appliance in water.
9. Fill the appliance with water only. Do not use descaling agents, fragrances, detergents, etc. Filling the water tank with anything other than water may damage the handheld steam cleaner.
10. Water filling procedure:
1) Disconnect the appliance from the mains
2) Press the steam release button to discharge residual pressure
3) Allow the appliance to cool
4) Press the steam release button again to discharge residual pressure
5) Open the safety cap and remove it after approximately 5 minutes.
(!) 11. Attention! The appliance heats up during operation, therefore do not touch hot surfaces; touch only the handle or steam release button. Always allow the appliance to cool before removing or attaching any accessories.
12. If the power cord is damaged, it must be replaced by the manufacturer, its service agent, or a similarly qualified person to avoid danger.
13. Before each cleaning or maintenance operation, disconnect the appliance from the mains and allow it to cool sufficiently.
14. This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or by persons lacking experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Do not allow children to play with the appliance.
15. Liquid or steam must not come into contact with equipment containing electrical components, for example, inside ovens.
16. Do not open the water filling safety cap during operation.
17. Do NOT use the appliance near sinks, bathtubs, or shower stalls containing water, or near running water.
18. Do NOT leave the appliance unattended while operating, hot, or under pressure. Ensure that children cannot touch the hot and/or pressurized appliance, or pull the power cord.
19. Do NOT use the appliance if it has been dropped or if any part of it (including cord or plug) is damaged. The handheld steam cleaner must be inspected and/or repaired by a qualified electrician before use.
20. Do NOT use the appliance under or near flammable materials (such as curtains, petroleum, fuel, etc.).
.Electrical Wiring
The handheld steam cleaner is equipped with a power cord with a grounding wire; therefore, it must be connected to a grounded power outlet. If you are unsure, consult a qualified electrician.
Never attempt to modify or replace the appliance’s power plug.
Ensure that the supply voltage corresponds to the voltage specified on the appliance’s rating plate.
Steam Warning Symbol: 
Be cautious with hot steam! Risk of burns. To avoid burns from hot steam, do NOT touch hot surfaces or the steam nozzle during or immediately after use.
Product Description
1. Power indicator
2. Power cord and plug
3. Steam release button
4. Safety cap
5. Short nozzle
6. Long extension spray nozzle
7. Measuring cup
8. Long spray tip
9. Funnel
10. Spray tip with round brush
11. Angled spray tip
12. Cloth
13. Spray tip for glass
14. Brush attachment
Principle of Operation of the Steam Generator
The principle of the steam generator’s operation is based on the effect of hot steam on dirt and contaminants. Steam penetrates into the dirt, softening and dissolving it, after which the dirt particles can be removed with a cloth or brush. The high temperature of the steam significantly enhances the cleaning process. Insoluble contaminants (such as grease deposits) are removed in a similar manner: under the influence of high-temperature steam, they soften, and the steam, combined with mechanical action on the contaminant, turns it into an emulsion consisting of small particles of dirt and water. This emulsion can then be easily wiped away with a cloth. In addition, hot steam effectively eliminates pathogenic microorganisms, bacteria, dust mites, mold, and fungi, which can cause allergic reactions and asthma.
During operation, the steam generator heats water in the tank to boiling temperature, converting it into steam, which then passes through the pipe and is delivered to the nozzle under pressure. The electronic circuit controls the water temperature in the tank, switching the heating on and off as necessary. The heating indicator on the appliance’s housing signals when the heating is active. This ensures a steady supply of steam.
.Preparation for Use
Warnings
(!) Caution! This appliance should not be used directly on soft plastics, untreated wood, or cold glass.
(!) Caution! Steam may damage furniture surfaces. To ensure safe use, please perform a test in an inconspicuous area first, or do not use if you are unsure.
Before use, pay particular attention to the relevant care instructions for furniture provided by the manufacturer of the item.
Assembling the Steam Cleaner
(!)
Attention!
Do not connect the appliance to the power supply until the step specified in point 7.
1. Remove the safety cap.
(!) NOTE: To remove the cap, press it down and turn counterclockwise. This is a design feature of the safety cap.
2. Fill the water tank with tap water. Please use the supplied measuring cup and funnel. It is recommended to fill the container no more than two-thirds full (the maximum level is indicated on the measuring cup).
(!) Note: Never pour descaling agents, fragrances, or detergents into the water tank, as this may damage the appliance.
3. Securely close the safety cap by pressing it down and turning clockwise until it is fully tightened.
4. Attach the required accessory (nozzle, hose, cleaning brush, etc.):
— Place the accessory onto the connector, aligning the “•” mark with the unlock symbol "
", and press it against the rubber seal.
— Turn the accessory clockwise (following the direction of the "
" symbol) until it reaches the locked position symbol "
".
5. Brush and angled nozzle: The brush and angled nozzle can be attached to the main unit using the extension hose or directly to the steam cleaner nozzle.
6. Glass cleaner: The glass cleaner must be attached to the scraper brush.
— First, secure the scraper brush to the appliance or hose.
— Remove the cloth from the scraper brush and attach the glass cleaner to the brush using the two hinges.
— The glass cleaner can be easily removed by pressing the latch tab.
(!) Warning! Do not use the appliance directly on cold glass.
The extension hose can be used for cleaning hard-to-reach areas and for additional convenience.
Operation
7. Connect the appliance to the power supply; the power indicator light should turn on. The appliance will take approximately 3–4 minutes to preheat, after which the indicator light should turn off. During preheating, do not disconnect the appliance from the power supply and do not press the steam release button.
When the indicator light turns off, the steam generator is ready for use. Press the steam release button and slowly move it over the surface to be cleaned.
It is recommended that the distance between the nozzle and the surface be at least 2–3 cm. It is normal for the indicator light to turn on and off during operation, as the thermostat automatically controls the heating element.
(!) Warning! During operation, the appliance should not be tilted more than 45°. Never direct the appliance towards people, animals, or plants.
8. Refilling the water tank:
— During operation, if you wish to refill the water tank, first disconnect the appliance from the power supply.
— Press the steam release button to fully release the internal pressure; continue this process for approximately 70–80 seconds until no more steam comes out of the nozzle (indicating that there is no remaining steam/pressure inside the appliance). For additional safety, please wait about 3 more minutes.
— You may then slowly open the safety cap.
— Once the appliance has cooled, fill the water tank to two-thirds full (maximum level indicated on the measuring cup). You may use the supplied funnel and measuring cup.
— Close the safety cap and reconnect the appliance to the power supply.
(!) Warning! Before opening the safety cap, ensure that the internal pressure has been sufficiently reduced. In addition, always allow the appliance to cool before removing the cap.
9. After use, disconnect the appliance from the power supply and drain the water from the tank.
10. Descaling: To maintain the high performance of your cleaner, we recommend descaling the appliance regularly (once a month).
— Do not use vinegar or other descaling agents for cleaning.
— Fill the water tank with water only. Shake the appliance manually and then empty the tank.
(!) Warning! Never immerse the appliance in water or other liquids.
(!) Caution! Never leave the appliance unattended while in use.
.Functions and Attachments
This appliance can be used for a variety of cleaning purposes and is highly versatile. You only need to fill it with tap water. It completely cleans, degreases, and disinfects without the use of any chemicals (>100°C) and is suitable for use on various materials and surfaces, such as windows, clothing, garden furniture, bicycles, cars, tiles, etc. This appliance is also ideal for disinfecting refrigerators, bathtubs, pillows, and carpets.
(!) Warning! Never direct the appliance towards people or animals.
Round brush: for kitchen, tiles, etc.
Brush for cleaning curtains, clothing, etc. Can be used together with a cloth and hose.
Glass cleaner: for windows, mirrors, glass doors, etc.
To clean windows, mirrors, and ceramic tiles, attach the steaming nozzle with the glass scraper to the steam generator.
(!) Caution! Do NOT direct steam onto cold glass.
.Straight nozzle: for joints, shelves, etc.
Angled nozzle: for toilets and hard-to-reach areas.
Hose: Ideal for extending the included accessories.
Storage and Maintenance of the Steam Cleaner
(!) Warning! After use, press the steam release button to sufficiently reduce the internal pressure. You may then remove the safety cap.
After using the appliance, drain any remaining water from the boiler (water tank). Then operate the appliance continuously until steam emission stops, ensuring that there is no water left in the boiler (water tank). After drying, store the appliance in a dry place.
Maintenance:
This appliance does not require special maintenance.
(!) Do not attempt to repair the appliance yourself. Repair of electrical appliances must be carried out only by a qualified electrician.
Troubleshooting
The appliance does not start
Possible cause:
— The appliance is not properly connected
— The power outlet is damaged
— The fuse has blown
— No water in the tank
Recommendations:
— Connect the appliance to the power supply
— Check the power outlet
— Replace the fuse
— Fill the tank with water
No steam
Possible cause:
— No water in the tank
Recommendations:
— Fill the tank with water
Water leaking from the nozzle
Possible cause:
— Too much water in the tank
— The appliance is tilted excessively
— The appliance is not sufficiently heated
Recommendations:
— Reduce the amount of water in the tank
— Hold the appliance correctly
— Allow the appliance to heat sufficiently
Steam escapes from the tank during filling
Possible cause:
— The water tank has not cooled down yet
Recommendations:
— Allow the appliance to cool
— Use the funnel
Accessory is loose
Possible cause:
— The accessory is not attached properly
Recommendations:
— Reattach the accessory
— Use the gasket
Other problems
Possible cause:
— The appliance is damaged
Recommendations:
— Contact a service center
User Manuals |