Assembly instructions for the stand for inflatable balloons

Assembly instructions for the balloon stand

Prepare the base

Fill the base with sand or water for stability

For better stability, fill the base with water or sand!

Assemble the vertical frame

Connect three thick tubes with two large connectors for secure attachment.

Assemble the vertical frame using thick tubes (2) and (4), alternating with connectors (3) and (5). Repeat this process until the required height is achieved. Where another tier (branch cluster) is planned, use connector (5).

Attach the vertical frame to the base

Insert the assembled construction into the prepared base

Assemble the tiers from thin tubes

Insert thin tubes into connectors (5), alternating their length

Assemble pairs of short and long thin tubes (20 and 35 cm) using adapters. Connect tubes (7) with adapter (8) to tubes (9), then add sockets (10). Insert all tubes into the connector holes, alternating long and short sticks for a decorative effect.

Place the large socket on top of the central tube

Install the large socket (6) at the top of the construction for the upper tier of balloons.

Sockets for attaching balloons

Place sockets on the ends of thin tubes

Attach sockets (10) to the remaining sticks (7, 9, 11).

Attach the balloons

Inflate the balloons and place them into the sockets at the tube ends

Such a comparison helps to properly orient oneself when inflating balloons for decoration.

• On the left (25 cm) — an underinflated balloon, slightly wrinkled and unable to maintain shape.
• In the center (28 cm) — an optimally inflated balloon, round and well-formed, marked with a green check mark.
• On the right (30 cm) — an overinflated balloon, excessively elongated and at high risk of bursting quickly.

The optimal balloon size for beginners is 10–12 inches. Balloons should be inflated to equal sizes (not more than 25 cm). Latex balloons are recommended.

(!) Note: balloon diameters may vary by manufacturer even for the same inch size.

(!) Always have spare balloons available to replace popped ones.

Adjust the bouquet composition

Arrange the balloons as desired to create a photo zone or festive decoration

The resulting arrangement will be about 70 cm in diameter (depending on balloon size).

Tips for balloon decoration

Plan the color composition in advance.
Avoid placing balloons on dusty or rough surfaces to prevent damage.
Tie balloon ends tightly for longer durability (up to 2 weeks).
For extended lifespan, coat balloon interiors with silicone before inflation.
Do not rub balloons together – they may pop.
Do not tape balloons with adhesive tape.
Step back and check the arrangement from all sides to ensure symmetry.