Portable jump starter Neoline Jump Starter 140. User Manual

Portable Universal Jump Inverter for Car Battery Neoline Jump Starter 140

Thank you for purchasing the Portable Universal Jump Inverter for Car Battery Neoline Jump Starter 140.
Please read this manual carefully and completely to use the device properly and extend its service life. Keep the user manual so that you can refer to it if necessary in the future.

Before using the Jump Starter portable charger, please carefully review this manual. The instruction contains a complete guide to using the inverter, including features, settings, installation recommendations, as well as the technical specifications of the device.

Device Description

Charge Indicator

Press the ON button to check the device’s charge level. When the inverter is charging, the indicator turns on automatically. The charge level can be viewed on the display.

Charging the Jump Starter 140 Inverter

1. Connect the charger to the 13V 1A input port of the Jump Starter 140, and then plug the charger into a 220V outlet.

2. If you are in a car, connect the charger to the 13V 1A input port of the Jump Starter 140 and insert the other end of the adapter into the vehicle cigarette lighter socket.

Starting the Vehicle Engine

1. Make sure the jump starter inverter charge level is at least 60%.

2. Connect the “crocodile” adapter to the car battery (red clamp – anode (+), black clamp – cathode (-)).

3. Insert the other end of the “crocodile” adapter into the output port of the device for 12V car battery start.

4. Turn the ignition key to the ON position and start the vehicle.

5. Once the car has started, carefully disconnect the “crocodile” adapter from the jump starter.

6. Disconnect the adapter clamps from the car battery terminals within 30 seconds.

Using the Jump Starter as a Power Bank for Other Portable Electronic Devices

1. Select the adapter suitable for your device.

2. Connect the cable to your device and insert it into the Jump Starter 140 inverter.

3. After the device is charged, remove the adapter first from the inverter and then from your device.

Charging Laptops / Portable DVD Players with Jump Starter

Choose the adapter and connector for the laptop from the set. Connect the adapter to the laptop and to the 19V output of the jump starter inverter. You may use the laptop while it is charging.

Charging Laptops / Portable DVD Players with Jump Starter

Choose the adapter and connector for the laptop from the set. Connect the adapter to the laptop and to the 19V output of the jump starter inverter. You may use the laptop while it is charging.

To connect a portable DVD player, select the 12V input. While charging the player, you can also watch movies.

Flashlight

To turn on the LED flashlight, press and hold the ON button for 5 seconds. The flashlight has several operating modes: Normal / Flashing / SOS / Off. To switch between modes, press the ON button.

Emergency Hammer

In case of emergency, break the car window with the emergency hammer located on the side of the Jump Starter 140 inverter.

Technical Specifications

• Battery capacity 14000 mAh
• Input 12V -1A
• Output 12V for car starting
5V-2A
12V-2A
19V-3.5A
• Starting current 200A
• Maximum current 300A
• Operating temperature from 0°C to +60°C
• Dimensions 160x75x28 mm
• Weight 430 g

Package Contents

• Universal jump inverter for car
• Charger for the jump starter from 220V
• Car starting cable with positive and negative clamps
• Adapters for different mobile devices
• Car cigarette lighter adapter

Compatibility with Batteries

The device is suitable for use with the following types of rechargeable batteries:
- AGM accumulators for Start-Stop systems
- Sealed GEL batteries
- VRLA / SLA accumulators with pressure relief valve
- WET batteries with liquid electrolyte
- EFB batteries with enhanced plate immersion