User Manual for Jump Starter Mini
A jump starter is essential for EVERY car owner. Anyone who has ever faced the problem of starting their vehicle due to a discharged battery (forgot to turn off the headlights/radio/listened to music outdoors, etc.) or a faulty battery knows that this usually happens unexpectedly, and finding someone willing to provide a “jump start” can be very difficult or even impossible. The Jump Starter is capable of starting a car engine with a completely discharged battery!
The jump starter will also help if the phone or tablet battery runs out – all the necessary adapters are included in the package.
The device has a built-in LED flashlight with three operating modes (bright light, strobe, SOS). The continuous operating time of the flashlight is more than 24 hours.
Technical Specifications of the Portable Charger
Battery capacity: 12000 mAh
Device dimensions (mm): 132 x 76 x 25
Device weight: 278 g
Operating temperature: -20°C~60°C
Starting current: 200 A (12V)
Peak starting current: 400 A
Input parameters for charging the device: 12V / 1A
Output parameters: – for mobile phones, tablets, and other digital portable devices: 5V/2A
Package Contents of the Charger
• Jump Starter Mini car jump starter – 1 pc.
• AC charger for charging the device from a 220V outlet – 1 pc.
• Car charger for charging the device from the vehicle’s on-board network – 1 pc.
• Power clamps for connecting to the car battery – 1 pc.
• Cable with adapters for charging mobile devices (Lightning, microUSB, iPhone 4S) – 1 pc.
• Adapter cable for charging a laptop – 1 pc.
• User manual – 1 pc.
Starting the Car Engine
1. Before starting the vehicle, please make sure that the device charge level is at least 3 bars (i.e., the internal battery is charged to no less than 60%). To check the charge, press the button once.
2. Connect the red clamp to the positive “+” terminal of the car battery and the black clamp to the negative “-” terminal. Pay special attention to ensure a reliable connection. This is crucial for successful engine starting!
3. Insert the connector of the power cables into the dedicated socket on the device.
4. Sit inside the car. Turn off all unnecessary power consumers (headlights, fan, radio, etc.).
5. Start the car in the usual way by turning the ignition key to the START position.
6. After the engine has started, disconnect the power clamps from the battery and unplug the cable from the jump starter.
7. Do not turn off the engine if the car battery requires charging. The charging time from the generator depends on the degree of discharge and the battery capacity.
Important! Never allow the power clamps to short-circuit!
Important! If the vehicle does not start on the first attempt, wait at least 1 minute before trying again to allow the battery to cool down, as it heats up during the start process.
Important! Starting a diesel engine should be done in the following sequence (if glow plugs are installed): turn on the ignition, then connect the jump starter, and start the engine.
.Strictly Prohibited!
1. Starting the engine without the standard car battery (this may cause damage to both the engine control unit and the emergency power device)!
2. Using the device in 100% humidity conditions!
3. Short-circuiting the power clamps connected to the device (the power output for starting engines is not equipped with overload and short-circuit protection)!
4. Allowing children or individuals unfamiliar with the device to use it!
Attention!
1. Before starting the engine in winter, keep the device in a warm place to achieve maximum starting current!
2. It is not recommended to leave the device in subzero temperatures for a long time.
3. Start the car engine with all electrical consumers turned off (headlights, heater, radio, etc.).
Charging Mobile Devices and Other Equipment
1. Connect the device to the USB port – charging will begin automatically.
Charging the Jump Starter Mini
1. Connect the power adapter (220V or car) supplied with the device to the 12V/1A input port to charge the built-in battery.
2. The charge indicator on the display will show the charging level of the battery.
Flashlight
Press and hold the button for 5 seconds to turn on the built-in flashlight. Then press the button to switch the flashlight mode (light, strobe, SOS).
Storage
Store the device in a cool, dry place away from direct sunlight.
Compatibility with Batteries
The device is suitable for use with the following types of rechargeable batteries:
- AGM accumulators for Start-Stop systems
- Sealed GEL batteries
- VRLA / SLA accumulators with pressure relief valve
- WET batteries with liquid electrolyte
- EFB batteries with enhanced plate immersion
User manuals portable chargers |