Elektronika 7-21-01 Electronic Clock Manual
Attention!
Before plugging the clock into the mains, carefully read this operating manual, including the purpose and layout of the controls.
GENERAL INFORMATION
When purchasing the Elektronika 7-21-01 electronic desk clock, request functionality testing, verify intact seals, and check completeness. Ensure that warranty and detachable coupons are present in the manual, with store stamp, seller’s signature or stamp, and date of purchase. To prevent malfunction after storage or transport in winter conditions, allow the device to rest at room temperature for 2–3 hours before plugging into the mains. Do not block ventilation openings on the rear panel.
GETTING STARTED
Plug the power cord into the mains. Random information will appear.
Press the PRG button and, while holding it, press C (reset). The hours and minutes indicators will reset. Symbols ВС and ПРГ will appear – the clock is ready for operation.
CURRENT TIME MODE
Press the * (preset) button. The display will dim (setup enabled).
Set the day of the week by pressing one of the buttons (0–6). Symbols ВС to СБ will appear.
Set tens of hours (0–2).
Set units of hours (0–9).
Set tens of minutes (0–5).
Set units of minutes (0–9).
Press the ^ arrow (save to memory).
At 00 seconds press the ТВ button. Timekeeping will start and separator dots will begin blinking.
.TIME CORRECTION
One minute before the time signal, press C (reset).
Enter the current time.
At the sixth signal (00 seconds) press the ТВ button.
ALARM MODE
Press PRG.
Press C (reset).
Press * (preset).
Press 7 (alarm).
Set alarm time.
Press ^ (save to memory).
Press ТВ.
DISABLING THE ALARM
Press the SIGNAL button.
ALARM CALL
Press PRG.
Press ТВ.
ALARM SETTING BY DAYS OF THE WEEK
The alarm can be set by weekdays.
Press PRG.
Press C (reset).
Press * (preset).
Press 7 (alarm).
Press C (switches to weekday setup mode).
Set alarm time.
Press ^ (save to memory).
Press ТВ.
Operating manuals for stationary clocks |