RGB LED color ring light with tripod and smartphone holder Manual operating instructions

RGB LED SOFT RING LIGHT User Manual in English

INTRODUCTION

Thank you for using the “RGB LED SOFT RING LIGHT.” This product is designed for professional and amateur photographers. Suitable for streaming, outdoor, and studio photography, as well as video recording for YouTube, Instagram, and TikTok. Proper use will improve your shooting experience. Please read this manual carefully before use.

Main features:

• Stepless color temperature adjustment, range 3200K–5500K, with high-CRI LEDs (>80 RA).
• Brightness control 1%–100%. Three white modes: natural, cool, warm.
• Ring-shaped design for uniform light distribution.
• Control via wired remote and wireless key fob.
• Adjustable tripod (70–200 cm) and phone/camera holder (5.5–8.5 cm). 360° rotation and adjustable tilt.
• 15 RGB combinations + 3 white modes. Special effects: lightning, police light, candle, TV, party, disco.

SAFETY PRECAUTIONS

Use only as a photography light with tripod and phone holder. Indoor use recommended. Not waterproof – keep away from rain and moisture. Avoid windy conditions outdoors. Always ensure the tripod is stable. Do not expose to direct sunlight. Disconnect when not in use. Children under 8 years should not use without supervision. Pack securely during transport. Avoid sharp parts near eyes. Check screws and joints regularly. If malfunction occurs, stop using and contact service. At end of life, disassemble and recycle materials separately.

DISCLAIMER

1. Read the manual carefully before use. Improper handling may cause injury or product damage.
2. By using the product, you acknowledge and accept all responsibility for its use and possible consequences.

COMPONENT OVERVIEW

1. Ring light
2. Roller
3. Lock handle
4. Tripod
5. Wired remote
6. Camera/smartphone holder
7. USB plug

ASSEMBLY

Mounting the ring light

Attach the swivel bracket to the tripod. Place the lamp onto the mounting screw and secure with roller (2). Adjust the angle and lock with handle (3).

Installing the holder

Screw the holder clockwise into the lamp base. Ensure it is firmly attached.

Tripod usage

Adjust tripod height, lock with screw clockwise. Unlock to extend. Insert tilt mechanism into bracket, secure with handle (3). Adjust tilt angle up to 180°.

REMOTE CONTROL

1. Brightness +
2. Brightness –
3. Power on/off
4. Color/mode switch
5. Color temperature selection

LIGHTING MODES

Modes: Cool (white), Natural (white+yellow), Warm (yellow). Adjust with the color switch button.