Ultrasonic Air Humidifier Ballu UHB-300 UHB-301 UHB-400 User Manual in Russian

Ultrasonic Air Humidifier Ballu UHB-300 UHB-301 UHB-400 User Manual

Before using the appliance, carefully study this manual and keep it in an accessible place.

(!) NOTE:
1. The manufacturer reserves the right to make changes to the design, package, or production technology without prior notice to improve performance;
2. Typos may be present in the manual or numerical labels;
3. If you still have questions after reading the manual, contact the seller or a specialized service center for clarification.

Safety Instructions

(!) WARNING!
• Before operating the humidifier, carefully read this user manual and keep it for future reference.
• The humidifier is designed to operate only from an AC power source. The AC voltage must correspond to the values specified in the “Technical Specifications” section.
• The humidifier is for use only in residential areas under the specified operating conditions. Improper use can create hazardous situations.

CAUTION!

• Children may not understand the dangers of using electrical appliances. Do not allow them to use or play with the appliance unsupervised. Keep the power cord out of children’s reach, even when the device is turned off.
• Store packaging materials (cardboard, plastic, etc.) out of children’s reach as they may pose a danger.
• Do not allow persons unfamiliar with this manual or under the influence of drugs or alcohol to use the device unsupervised.
• Do not use the humidifier if the power cord or plug is damaged, or if the humidifier is malfunctioning, damaged by falling, or under other circumstances. The humidifier must only be operated when fully assembled.
• Repairs should only be carried out by qualified specialists. To avoid injury or property damage, do not attempt to repair the humidifier yourself.
• Always unplug the humidifier in the following cases:
– before draining or filling the water tank;
– before cleaning and maintenance;
– before assembling/disassembling components;
– before moving the humidifier.
• Do not pull the power cord or touch it with wet hands when unplugging.
• Place the humidifier on a flat, dry surface.
• Do not place the humidifier near electric heaters.
• The manufacturer and seller are not responsible for damage due to improper placement.
• Do not immerse the humidifier in water or liquids.
• Do not place the humidifier in passages or areas where it may be bumped or tipped.
• Disconnect from the mains if not in use.
• Do not run the power cord under carpets or objects.
• Position the humidifier so that the cord cannot be accidentally pulled.
• Do not use in areas with explosive materials or flammable gases.
• Do not use in damp rooms.
• Do not allow foreign objects inside.
• Do not block air intake or the nozzle.
• Do not sit, stand, or place heavy objects on the humidifier.
• Do not add essential oils, preservatives, fragrances, or other substances to the water. This will damage the unit and void responsibility of the manufacturer and seller.

Purpose of the Device

Congratulations on purchasing the BALLU UHB-300/301/400 humidifier (hereinafter “humidifier”). It is designed to maintain a desired level of relative humidity indoors. Comfortable humidity is between 40% and 60%.

The humidification process is based on the “ultrasonic evaporation” principle. Water entering the chamber is broken into fine droplets by ultrasound. These microscopic droplets form a mist cloud, which a small fan blows into the room.

Low humidity indoors causes dry mucous membranes, cracked lips, burning eyes, increased spread of infections, respiratory diseases, fatigue, eye strain, poor concentration, negative effects on pets and plants, increased dust, and electrostatic charge in fabrics, carpets, and flooring. It can damage wooden furniture, parquet floors, and affect the tuning of musical instruments.

The high-frequency oscillations of the ultrasonic membrane are inaudible and completely safe for humans and pets.

(!) IMPORTANT!
When first switched on, the desired humidity level will only be reached after 7–10 days of continuous operation. This is because moisture is initially absorbed by walls, floors, and furniture. Only after they are saturated will the room humidity stabilize.

Device Structure

1. Rotating steam nozzle
2. Tank backlight (installed in base)
3. Aroma oil container
4. Water tank
5. Tank lid (bottom of tank)
6. Filter cartridge (installed in tank lid)
7. Operation and water level indicator
8. Steam intensity control knob
9. Humidifier base
10. Tank backlight switch

Technical Specifications

Model: UHB-300/301/400
Rated voltage, V~Hz: 220 ~ 50
Power consumption, W: 28
Current, A: 0.25
Noise level, dB(A) ? 35
Moisture protection: IPX0
Electrical safety class: II
Tank volume, L: 2.8
Humidification rate, ml/h: up to 300
Recommended room area, m?*: up to 40
Unit dimensions (WxHxD), mm: 198x288x198
Package dimensions (WxHxD), mm: 230x315x230
Net weight, kg: 1.15
Gross weight, kg: 1.6

* Approximate coverage. Actual performance may vary depending on operating conditions.

Filling the Water Tank

1. Remove the nozzle from the tank. If not, it may fall when the tank is turned over.

2. Remove the water tank from the base:
• Hold the sides of the tank and lift upwards.
• Unscrew the tank lid counterclockwise.

3. Fill the tank with tap water.

(!) WARNING!
• Do not add substances such as essential oils, fragrances, detergents, chemicals, hot water (above 40 °C), etc. Doing so will damage the tank and internal parts.
• Only fill with tap water. Other liquids will damage internal components.
• Do not pour water directly into the unit or nozzle.
• Do not hit or drop the tank. Damage may cause leaks. If the tank is damaged, contact service immediately.
• Refill with clean water daily and keep the unit clean.

4. Ensure the lid is securely tightened. The rubber ring must be in place. Incomplete tightening may cause leaks between the tank and lid.

5. Place the tank back on the unit and reinstall the nozzle. Without the nozzle, steam will condense on the top cover and surrounding surfaces.

Connection and operation of the device

1. Connect the device plug to the power supply.

(!) WARNING!
Use an alternating current power source specified in the technical specifications of the device. Exceeding the voltage leads to malfunction, which may cause fire.

(!) WARNING!
Do not use the device with a faulty power cable or plug, as well as with a loose socket. This may cause sparking, short circuit, or electric shock.

(!) WARNING!
Do not turn on the power while draining water or when the device is in an inverted position. This may lead to malfunction.

2. To turn on the device, rotate the steam output control knob to the right (clockwise). After a few seconds, steam will begin to come out of the sprayer. At the very beginning of this operation, the spraying level may be unstable due to the difference in temperature and water quality. Some time is required for the water to transform into steam inside the nozzle and for this process to stabilize. After 10–25 minutes of operation, the spraying level gradually stabilizes.

Setting the spraying frequency

By turning the steam output control knob clockwise, you set the humidification rate. The more you rotate the switch, the higher and faster the humidification rate will be.

Water purification system

Tap water may be poured into the reservoir. The included filter cartridge softens the water and removes hardness salts.

Aromatherapy

For aromatherapy, it is necessary to remove the container for aromatic oils and add a few drops of any essential oil onto the special pad installed in the container. Place the container back and turn on the device.

Shutting down the device

Turn the steam control knob counterclockwise (to the left) until it clicks. The device operation indicator will turn off. The device will switch off. Remove the plug from the socket. Automatic shutdown occurs at the minimum water level.

When the water level in the base reaches the minimum, the humidifier automatically shuts down. The operation indicator lights up red, indicating the absence of water. To continue using the device, it is necessary to add water to the reservoir.

(!) WARNING!
When removing the tank, water may remain in the accumulation reservoir. To avoid spilling water on the floor or furniture, dry the bottom of the reservoir with a towel before removing it. Do not drop or hit the reservoir when filling/emptying it. In case of falling or strong impact, the reservoir may crack and leak.

* At the first startup or after refilling with water, the filling indicator may glow red. In this case, the water passes through the filter cartridge, and it may take some time (1–3 minutes) to fill the working chamber with water.

Tank lighting – switching on and off

If necessary, the reservoir illumination can be switched on/off. To do this, move the illumination switch to the desired mode. The switch is located in the lower part of the humidifier base.

Ion exchange water filter cartridge

FC-400 filter cartridge

The device package includes a filter with ion exchange resin. Prolonged use of the humidifier without replacing the filter may result in white deposits on the device and nearby objects.

White deposits consist of calcium and magnesium, which are contained in ordinary tap water. When the ion exchange resin in the filter is exhausted, these substances together with the steam enter the room and settle on surrounding objects and surfaces.

Although these substances are safe for humans, in large quantities they can have a harmful effect on furniture. With the help of the ion exchange filter installed in the reservoir cover, calcium and magnesium are removed from tap water.

Filter replacement

The useful service life of the ion exchange filter is about 150 liters. Prolonged use beyond its service life reduces the ability to filter hardness components (calcium and magnesium) from tap water. As a result, the level of white deposit formation increases.

The standard replacement period for the filter is about 45 days, provided regular operation (humidification time — about 8 hours daily). Depending on usage frequency and water quality, the replacement period may be shorter.

The ion exchange filter is installed in the water reservoir cover. To replace the filter, remove the cover by turning it counterclockwise, and then remove the filter by pulling the cover and filter apart (see fig. 4). Install the new filter in the reverse order.

To purchase an FC-400 ion exchange filter, please contact the seller or an authorized service center.

Cleaning and maintenance of the device

(!) WARNING!
Before starting cleaning, make sure that the plug is disconnected from the socket. Otherwise, this may lead to electric shock.

Maintenance of the outer surface of the device

For maintenance of the outer surface, use a soft damp cloth.

(!) WARNING!
To avoid electric shock, do not scratch or damage the device components during cleaning. Do not use solvent, gasoline, xylene, hard brush, talcum powder, or other substances except water when cleaning the device.

Maintenance of water grooves

Wipe off the remaining water inside the groove under the reservoir with a soft damp cloth. Clean the device once a week.

Cleaning the membrane

If dirt appears on the membrane, clean it with a soft brush. Perform cleaning once or twice a week.

Maintenance of the sprayer nozzle

Use a brush to remove water residues on the surface of the nozzle, and then wipe again with a soft cloth. Clean the device once a week.

(!) WARNING!
To avoid deformation and wear of working surfaces, which may lead to reduced spraying or other malfunctions, do not use metal brushes, blades, or talcum powder for wiping the nozzle surface.

1. To remove the remaining water inside, remove the sprayer; otherwise, when removing the reservoir, the sprayer will fall. To remove the reservoir cover located at the base of the tank, turn it counterclockwise.

2. Rinse the water reservoir and sprayer with clean water. Wash the cover carefully and without excessive force.

3. After removing water residues from the sprayer surface, wipe it with a soft cloth. Clean the outer surface of the device with a soft damp cloth.

Maintenance after cleaning

1. To keep the device dry, remove the water after cleaning and be sure to dry the reservoir and device body.

2. Make sure that no water remains inside the reservoir and the device body.

Troubleshooting

In case of operational issues or malfunctions, refer to the troubleshooting methods listed in the tables. If the issues cannot be resolved by the specified methods, please contact the service center.

Device service life

The service life of the humidifier is 5 years.

Storage of the device

Clean the humidifier, dry it thoroughly. It is recommended to store the device in the original box at room temperature.

Air humidity is one of the vital indicators for maintaining human health. Air always contains water vapor, its percentage depends on the ambient temperature. The higher the temperature, the more water vapor is contained in the air. In modern reinforced concrete and brick buildings, especially in winter, a low level of humidity is observed.

Before starting operation of the device, carefully read this manual, which contains important information regarding your safety, as well as recommendations for proper use and maintenance of the device.

Keep this manual together with the warranty card, cash receipt, if possible, cardboard box, and packing material.

Warranty

Warranty service of the humidifier is carried out in accordance with the warranty obligations listed in the warranty card.

Package contents

1. Air humidifier
2. Water filter cartridge
3. Instruction manual
4. Warranty card included in the instruction

Device disposal

After the expiration of the service life, the device must be disposed of in accordance with the regulations, rules, and procedures in force at the place of disposal.

Do not dispose of the device together with household waste.

After the expiration of the service life of the device, deliver it to a collection point for disposal, if this is provided for by the regulations and rules of your region. This will help avoid possible environmental and health consequences, as well as contribute to the reuse of the product components.

Information on where and how to dispose of the device can be obtained from local authorities.